Monday, September 6, 2010

Decoder Uhlenbrock 73410

Este es un decoder multiprotocolo de tamaño minúsculo con conexión NEM651. Además, detecta si está funcionando en analógico (corriente continua) o digital (alterna) automáticamente, así que podemos usarlo en maquetas con los 2 sistemas. Permite controlar las luces y configurar las inercias de arrancada y parada de la locomotora, velocidades maximas, conexión para Intellisound y Lissy, y se puede programar en la vía principal. En casi cualquier locomotora encontraréis espacio para instalarlo.

Las especificaciones en inglés son:

Regulated Multi-protocol decoder for DCC, Motorola
• Suitable for DC and Bell armature motors up to 0.6A
• Quiet motor running with 18.75KHz control frequency
• 14, 27, 28, 31 and 128 speed steps depending on the data format
• Short (1-127) and long (128-9999) addresses
• NMRA compatible
• Minimum, maximum and middle speeds adjustable
• Speed step table for 14, 28 and 31 speed steps
• Main line programming (DCC)
• Shunting speed (half speed) switched with F3
• Direction dependent, dimmable lighting switched via F0
• With solder pads for connecting Uhlenbrock IntelliSound modules or LISSY Mini transmitter
• Reacts to DCC brake signal (e.g. from Power 3) “Brake diode” or braking section in DC
operation.
• All outputs have short circuit protection
• Conventional DC operation with automatic switching between DC and digital mode
• All CVs programmable by digital devices with DCC and Motorola formats
• Programmable via register, direct CV or page mode in DCC operation
• Updatable using Flash memory

Main CV:

CV 1:  Locomotive address DCC 1-127
CV 2: Minimum speed value 1-63 (1)
CV 3: Start Inertia 1-63 (2)
CV 4: Braking inertia (time factor like CV3) 1-63 (2)
CV 5: Maximum speed (must be lager than CV2) 1-63 (48)
CV 6: Middle speed 1-63 (24)
CV 7: Software version (The processor used can be updated)

CV 50: Dimming of the function outputs 0-32 (16)

No comments:

Post a Comment